Pushbuttons
-
The four pushbuttons let
you
return to favorite stations. To
set
the pushbuttons for up to fourteen favorite stations
(7
AM and
7
FM):
1.
Tune in the desired station.
2. Push the SET button. “SET” appears in the display for about
5
seconds.
3.
Within the
5
seconds, push
one
of the four pushbuttons. Whenever you
press that button, the preset station will return.
NOTE:
In addition to the four stations set as above, up
to
three additional stations
may be preset on each band by pressing two adjoining pushbuttons at the
same time. Then do the following:
I.
Tune in the desired station.
2. Press the SET button.
3.
Within
5
seconds, press any two adjoining pushbuttons at the same
time. (The station will return when the same two buttons are pressed
again.)
Adjust the Tone
-
Use the levers in the upper middle left corner to set the
bass, midrange, and treble until you get the sound you want. The
60
and
250
levers adjust the bass,
1
K
is midrange, and
3.5K
and
1OK
control the treble.
We suggest
you
start with the center lever
(1
K)
in the midpoint position,
then move the others up until
you
get the amount
of
bass and treble
you
like.
Am-St Button
-
The Am-St button
is
just below the SEARCH button.
Push this when
you
tune
to
an AM station that broadcasts in stereo. Your
STEREO light will come on when you’re receiving AM stereo. If
you
push
Am-St and there is
no
more noise, it means the station
is
weak. You’ll hear
the
station better if you don’t
use
Am-St. Just push the Am-St button again
to delete stereo.
AUTO DNR@
-
This unit is equipped with an automatic Dynamic Noise
Reduction system. DNR@reduces background hiss
on AM and FM radio
broadcasts, as well as
on
cassette tapes. DNR@is a registered trademark of
National Semiconductor Corporation.
To
Flay
A
Cassette
Your tape player is built
to
work best with tapes that are
30
to
45
minutes
long on each side. Tapes longer than that are
so
thin they may
not
work well
in
this player.
Once the tape is playing, use the upper and lower knobs for volume, balance
and fade
just
as
you
do for the radio. A lighted arrow shows which direction
the tape is being played,
02
-
The Cr02 button lets you
set
the system for the type
of
cassette
being used. If
you
are using chrome or metal tapes, push the Cr02 button
in.
3-11
To Next Page
Loading...
Need help?
General
