7-3
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
OL-5052-08
Chapter 7 Troubleshooting the Installation
Packing a SPA for Shipment
For information about other debug commands supported on the To view the explanations and
recommended actions for the Cisco 7600 series router error messages, including messages related to
Cisco 7600 SIPs and SPAs, refer to the following documents:
• Cisco 7600 Series Cisco IOS System Message Guide, 12.2SX (for error messages on Early
Deployment trains)
• System Error Messages for Cisco IOS Release 12.2S (for error messages in Release 12.2S)
Packing a SPA for Shipment
This section provides step-by-step instructions for packing a SPA and the cable-management brackets
for shipment. Before beginning this procedure, you should have the following original Cisco Systems
packaging materials:
• Thermoform container (transparent plastic-molded clamshell)
• Carton
Caution Use Cisco Systems original packaging for the shipment of all SPAs and cable-management brackets.
Failure to properly use Cisco Systems packaging can result in damage or loss of product.
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
Statement 94
Note These instructions assume that the SPA and cable-management brackets have been removed from the
router according to the recommended procedures specified in this guide.
To pack a SPA and the cable-management brackets for shipment, follow these steps:
Step 1 Open the thermoform container and place the SPA and each of the cable-management brackets into the
appropriate cavities.
Caution Always handle the SPA by the carrier edges and handle; never touch the SPA components or connector
pins.
Step 2 Close the thermoform container. Be sure to lock the snaps securely.
Step 3 Check that the thermoform container is fully closed. Apply tape or a label closure over the opening to
ensure that the container stays closed during shipping.
Step 4 Place the thermoform container into the carton.
Step 5 Close the carton.
Step 6 Apply tape over the carton flap to ensure that the carton stays closed during shipping.
To Next Page
Loading...
Need help?
General
