Cisco 7600 Series User Manual

2-2
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
OL-5052-08
Chapter 2 Overview: Cisco 7600 Series SIPs
Identifying Slots and Subslots for SIPs and SPAs
Checking Hardware and Software Compatibility
To check the minimum software requirements of Cisco IOS software with the hardware installed on your
router, Cisco maintains the Software Advisor tool on Cisco.com. This tool does not verify whether SIPs
or SPAs within a system are compatible, but it does provide the minimum Cisco IOS requirements for
individual hardware modules or components.
Note Access to this tool is limited to users with Cisco.com login accounts.
To access Software Advisor, click Login at Cisco.com, type “Software Advisor” in the SEARCH box,
and click GO. Click the link for the Software Advisor tool.
Choose a product family or enter a specific product number to search for the minimum supported
software release needed for your hardware.
Identifying Slots and Subslots for SIPs and SPAs
This section describes how to specify the physical locations of a SIP and SPA on the Cisco 7600 series
routers within the command-line interface (CLI) to configure or monitor those devices.
Note For simplicity, any reference to “SIP” in this section also applies to the SSC.
Specifying the Slot Location for a SIP or SSC
The Cisco 7600 series router supports different chassis models, each of which supports a certain number
of chassis slots.
Note The Cisco 7600 series router SIPs are not supported with a Supervisor Engine 1, Supervisor Engine 1A,
Supervisor Engine 2, or Supervisor Engine 720-3A.

Cisco 7600 Series Specifications

General

Brand	Cisco
Model	7600 Series
Category	Network Router
Language	English