7-4
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
OL-5052-08
Chapter 7 Troubleshooting the Installation
Packing a SIP for Shipment
Packing a SIP for Shipment
This section provides step-by-step instructions for packing a SIP for shipment. Before beginning this
procedure, you should have the following original Cisco Systems packaging materials:
• Static shielding bag
• Smaller inner carton
• Larger exterior carton
• Two foam packing cushions
Caution Use Cisco Systems original packaging for the shipment of all SIPs. Failure to properly use Cisco
Systems packaging can result in damage or loss of product.
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
Statement 94
Note These instructions assume that the SIP has been removed from the router according to the recommended
procedures specified in this guide.
To pack a SIP for shipment, follow these steps:
Step 1 Insert the SIP into the static shielding bag.
Step 2 Insert the bagged SIP into the smaller inner carton. Be careful to position the SIP so that the bottom
motherboard lip is held by the packaging cutout.
Step 3 Close the smaller inner carton and tape the sides closed.
Step 4 Place the sealed smaller inner carton containing the SIP into the two foam packing cushions (they only
fit one way).
Step 5 Place the sealed smaller inner carton and packing cushions into the larger exterior carton, and seal the
larger exterior carton with tape for shipment.
To Next Page
Loading...
Need help?
General
