Activation codes can be used only once, and have an expiry date. If a user enters an expired code, the phone
displays Invalid activation code on the screen. If this happens, provide the user with a new code.
This feature is available in firmware release 11-2-3MSR1, BroadWorks Application Server Release 22.0
(patch AP.as.22.0.1123.ap368163 and its dependencies). However, you can change phones with older firmware
to use this feature. To do this, use the following procedure.
Before you begin
Ensure that you allow the activation.webex.com service through your firewall to support onboarding via
activation code.
Access the phone web page . See Access the Phone Web Page, on page 80
Procedure
Step 1 Reset the phone to the factory settings.
Step 2 Select Voice > Provisioning > Configuration Profile.
Step 3 Enter the profile rule in the Profile Rule field in this format: gds://
Step 4 Select Firmware Upgrade.
Step 5 Enter the upgrade rule in the Upgrade Rule field in this format: http://<server ip
address>/sip88xx.11-2-3MSR1-1.loads/
Step 6 Submit All Changes.
See below a sample cfg.xml file showing the profile rule, and upgrade rule.
<?xml version="1.0" encoding="UTF-8"?>
<device>
<flat-profile>
<!-- System Configuration -->
<Profile_Rule ua="na">gds://</Profile_Rule>
<!-- Firmware Upgrade -->
<Upgrade_Enable ua="na">Yes</Upgrade_Enable>
<Upgrade_Error_Retry_Delay ua="na">3600</Upgrade_Error_Retry_Delay>
<Upgrade_Rule ua="na">http://<server ip address>/sip88xx.11-2-3MSR1-1.loads</Upgrade_Rule>
<!-- <BACKUP_ACS_Password ua="na"/> -->
</flat-profile>
</device>
Configure the Network from the Phone
The phone includes many configurable network settings that you may need to modify before it is functional
for your users. You can access these setting through the phone menus.
The Network configuration menu provides you with options to view and configure a variety of network
settings.
You can configure settings that are display-only on the phone in your Third-Party Call Control system.
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
36
Cisco IP Phone Installation
Configure the Network from the Phone
To Next Page
Loading...
Need help?
General
