FunctionDigit Sequence
This format indicates that certain dialed digits are replaced by the
substituted characters when the sequence is transmitted. The dialed
digits can be zero to 9. For example:
<8:1650>xxxxxxx
When the user presses 8 followed by a seven-digit number, the system
automatically replaces the dialed 8 with the sequence 1650. If the user
dials 85550112, the system transmits 16505550112.
If the dialed parameter is empty and there is a value in the substituted
field, no digits are replaced and the substituted value is always
prepended to the transmitted string. For example:
<:1>xxxxxxxxxx
When the user dials 9725550112, the number 1 is added at the
beginning of the sequence; the system transmits 19725550112.
<dialed:substituted>
An intersequence tone played (and placed) between digits plays an
outside line dial tone. For example:
9, 1xxxxxxxxxx
An outside line dial tone plays after the user presses 9. The tone
continues until the user presses 1.
, (comma)
Prohibits a dial sequence pattern. For example:
1900xxxxxxx!
Rejects any 11-digit sequence that begins with 1900.
! (exclamation point)
Allows a user to enter a 2-digit star code.*xx
For Interdigit Timer Master Override, enter S0 to reduce the short
interdigit timer to 0 seconds, or enter L0 to reduce the long interdigit
timer to 0 seconds.
S0 or L0
To pause, enter P, the number of seconds to pause, and a space. This
feature is typically used for implementation of a hotline and warm
line, with a 0 delay for the hot line, and a nonzero delay for a warm
line. For example:
P5
A pause of 5 seconds is introduced.
P
Digit Sequence Examples
The following examples show digit sequences that you can enter in a dial plan.
In a complete dial plan entry, sequences are separated by a pipe character (|), and the entire set of sequences
is enclosed within parentheses:
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
64
Cisco IP Phone Installation
Digit Sequence Examples
To Next Page
Loading...
Need help?
General
