Cisco 7941G - Unified IP Phone VoIP User Manual

2-19
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.1
OL-14620-01
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Using Cisco Unified IP Phones with Different Protocols
Using Cisco Unified IP Phones with Different
Protocols
The Cisco Unified IP Phone can operate with SCCP (Skinny Client Control
Protocol) or SIP (Session Initiation Protocol). You can convert a phone that is
using one protocol for use with the other protocol.
This section includes these topics:
• Converting a New Phone from SCCP to SIP, page 2-19
• Converting an In-Use Phone from SCCP to SIP, page 2-20
• Converting an In-Use Phone from SIP to SCCP, page 2-20
• Deploying a Phone in an SCCP and SIP Environment, page 2-21
Converting a New Phone from SCCP to SIP
A new, unused phone is set for SCCP by default. To convert this phone to SIP,
perform these steps:
Procedure
Step 1 Take one of these actions:
• To auto-register the phone, set the Auto Registration Phone Protocol
enterprise parameter in Cisco
Unified Communications Manager
Administration to SIP.
• To provision the phone by using the Bulk Administration Tool (BAT), choose
the appropriate phone model and choose SIP from BAT.
• To provision the phone manually, make the appropriate changes for SIP on
the Phone Configuration window in Cisco
Unified Communications Manager
Administration.
Refer to Cisco Unified Communications Manager Administration Guide for
detailed information about Cisco
Unified Communications Manager
configuration. Refer to Cisco Unified Communications Manager Bulk
Administration Guide for detailed information about using the BAT.

Cisco 7941G - Unified IP Phone VoIP Specifications

General

Brand	Cisco
Model	7941G - Unified IP Phone VoIP
Category	IP Phone
Language	English