Cisco 7941G - Unified IP Phone VoIP User Manual

Chapter 3 Setting Up the Cisco Unified IP Phone
Understanding the Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE Components
3-4
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.1
OL-14620-01
– labeled 10/100/1000 SW on the 7961G-GE and 7941G-GE
• Access port
– labeled 10/100 PC on the 7961G and 7941G
– labeled 10/100/1000 PC on the 7961G-GE and 7941G-GE
Each port supports 10/100 Mbps or 10/100/1000 half- or full-duplex connections
to external devices. You can use either Category 3 or 5 cabling for 10 Mbps
connections, but you must use Category 5 for 100 and 1000 Mbps connections.
Use the SW network port to connect the phone to the network. You must use a
straight-through cable on these ports. The phone can also obtain inline power
from a switch over these connections. See the
“Adding Phones to the Cisco
Unified Communications Manager Database” section on page 2-14 for details.
Use the PC access port to connect a network device, such as a computer, to the
phone. You must use a straight-through cable on this port.
Handset
The handset is designed especially for use with a Cisco Unified IP Phone. It
includes a light strip that indicates incoming calls and voice messages waiting.
To connect a handset to the Cisco Unified IP Phone, remove the hookswitch clip
(see illustration below) from the cradle area. Then plug the cable into the handset
and into the Handset port on the back of the phone.
Figure 3-1 Removing the Hookswitch Clip
185165

Cisco 7941G - Unified IP Phone VoIP Specifications

General

Brand	Cisco
Model	7941G - Unified IP Phone VoIP
Category	IP Phone
Language	English