CHAPTER 2
Prepare to Install
• General Safety Guidelines, on page 47
• Safety Instructions, on page 48
• Warning Definition, on page 48
• Preventing Electrostatic Discharge Damage, on page 49
• Plant Wiring Guidelines, on page 49
• Electrical Equipment Guidelines, on page 50
• Unpacking and Verifying Shipping Contents, on page 50
• Chassis-Lifting Guidelines, on page 51
• General Rack Installation Guidelines, on page 51
• Cabling Guidelines, on page 53
General Safety Guidelines
When you install any component in a chassis, observe all caution and warning statements mentioned in this
chapter. For warning translations, see the regulatory compliance and safety documentation that came with
this product.
The following guidelines will help ensure your safety and protect the equipment. However, these guidelines
may not cover all potentially hazardous situations you may encounter during system installation, so be alert.
• Install your product in compliance with the national and local electrical codes. In the United States, this
means the National Fire Protection Association (NFPA) 70, United States National Electrical Code. In
Canada, Canadian Electrical Code, part I, CC22.1. In other countries, International Electrotechnical
Commission (IEC) 364, part 1 through part 7.
• Review the safety warnings listed in the regulatory compliance and safety documentation before installing,
configuring, or performing maintenance on the product.
• Disconnect power at the source before you install or remove a chassis.
• Do not attempt to lift an object you might find too heavy to lift safely.
• Keep the chassis area clear and as dust free as possible during and after installation.
• Keep tools and chassis components away from walk areas.
• Do not wear loose clothing, jewelry (including rings and chains), or other items that could get caught in
the chassis.
Cisco Converged Broadband Routers Hardware Installation Guide
47
To Next Page
Loading...
Need help?
General
