Cisco SF200-24 User Manual

Configuring IP Information
Management and IP Interfaces
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 215
16
Defining IPv6 Global Configuration
The IPv6 Global Configuration page defines the frequency of the IPv6 ICMP error
messages generated by the switch.
To define IPv6 global parameters:
STEP 1 Click Administration > Management Interface (Layer 2) > IPv6 Global
Configuration.
The IPv6 Global Configuration page opens.
STEP 2 Enter values for the following fields:
• ICMPv6 Rate Limit Interval—Enter the time limit.
• ICMPv6 Rate Limit Bucket Size—Enter the maximum number of ICMP error
message that can be sent by the switch per interval.
STEP 3 Click Apply. The IPv6 global parameters are defined, and the Running
Configuration file is updated.
Defining an IPv6 Interface
The IPv6 Interfaces page displays the switch’s IPv6 interface parameters and
enables configuring this interface. An IPv6 interface can be configured on a port, a
LAG, VLAN, or ISATAP tunnel interface. The switch supports one IPv6 interface as
an IPv6 end device.
A tunnel interface is configured with an IPv6 address based on the settings
defined in the IPv6 Tunnel page.
To configure IPv6 interfaces:
STEP 1 Click Administration > Management Interface (Layer 2) > IPv6 Interfaces.
The IPv6 Interface page opens.
This page displays the IPv6 interfaces already configured.
STEP 2 Click Add to add a new interface on which interface IPv6 is enabled.
STEP 3 The Add IPv6 Interface page opens.
STEP 4 Enter the values.

Cisco SF200-24 Specifications

General

Brand	Cisco
Model	SF200-24
Category	Switch
Language	English