General Administrative Information and Operations
System Information
Cisco Small Business 200 1.1 Series Smart Switch Administration Guide 44
6
System information:
• System Description—A description of the system.
• System Location—Physical location of the switch. Click Edit to go the
System Settings page to enter this value.
• System Contact—Name of a contact person. Click Edit to go the System
Settings page to enter this value.
• Host Name—Name of the switch. Click Edit to go the System Settings
page to enter this value. By default, the switch hostname is composed of
the word switch concatenated with the three least significant bytes of the
switch MAC address (the six furthest right hexadecimal digits).
• System Uptime—Time that has elapsed since the last reboot.
• Current Time—Current system time.
• Base MAC Address—Switch MAC address.
• Jumbo Frames—Jumbo frame support status. This support can be
enabled or disabled by using the Port Setting page.
NOTE Jumbo frames support takes affect only after it is enabled, and after
the switch is rebooted.
TCP/UDP Services Status:
• HTTP Service—Displays whether HTTP is enabled/disabled.
• HTTPS Service—Displays whether HTTPS is enabled/disabled.
• Edit—Clicking on this takes you to
TCP/UDP Services
page. See
Configuring Security
for details.
Hardware and firmware version information:
• Model Description—Switch model description.
• Serial Number—Serial number.
• PID VID—Part number and version ID.
• Firmware Version—Firmware version number of the software image.
• Firmware MD5 Checksum—MD5 checksum of the software image.
• Boot Version—Boot version number.
• Boot MD5 Checksum—MD5 checksum of the boot version.
To Next Page
Loading...
Need help?
General
