Cisco Unified IP Phone 8941 User Manual

DescriptionItem
Indicates whether CDP is supported on the switch port (default is enabled).
Enable CDP on the switch port for VLAN assignment for the phone, power negotiation,
QoS management, and 802.1x security.
Enable CDP on the switch port when the phone is connected to a Cisco switch.
When CDP is disabled in Cisco Unified Communications Manager, a warning is presented,
indicating that CDP should be disabled on the switch port only if the phone is connected
to a non-Cisco switch.
The current PC and switch port CDP values are shown on the Settings menu.
CDP: SW Port
Network Statistics
The following network statistics hyperlinks on a phone web page provide information about network traffic
on the phone.
Ethernet Information Web Page
The following table describes the items in this area.
Table 24: Ethernet Information Items
DescriptionItem
Total number of packets transmitted by the phoneTx Frames
Total number of broadcast packets transmitted by the phoneTx broadcast
Total number of unicast packets transmitted by the phoneTx unicast
Total number of packets received by the phoneRx Frames
Total number of broadcast packets received by the phoneRx broadcast
Total number of unicast packets received by the phoneRx unicast
Access Area and Network Area Web Pages
The following table describes the items in this area.
Table 25: Access Area and Network Items
DescriptionItem
Number of packets transmitted by the phoneTx Frames
Number of broadcast packets transmitted by the phoneTx broadcast
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0 (SCCP
and SIP)
157
Cisco IP Phone Web Page

Cisco Unified IP Phone 8941 Specifications

General

Brand	Cisco
Model	Unified IP Phone 8941
Category	IP Phone
Language	English