Cisco Unified IP Phone 8941 User Manual

To changeDescriptionOption
Set PC Port Setup Field, on page 37Speed and duplex of the access port. Valid
values:
•
Auto Negotiate
•
1000 Full: 1000-BaseT/full duplex
•
100 Half: 100-BaseT/half duplex
•
100 Full: 100-BaseT/full duplex
•
10 Half: 10-BaseT/half duplex
•
10 Full: 10-BaseT/full duplex
If the phone is connected to a switch,
configure the port on the switch to the same
speed/duplex as the phone, or configure
both to autonegotiate.
If you change the setting of this option, you
must change the SW Port Configuration
option to the same setting.
PC Port Setup
From Cisco Unified Communications
Manager Administration, choose
Device > Phone > Phone
Configuration.
Enables and disables Link Layer Discovery
Protocol Media Endpoint Discovery
(LLDP-MED) on the switch port. Use this
setting to force the phone to use a specific
discovery protocol, which should match the
protocol supported by the switch. Settings
include:
•
Enabled (default)
•
Disabled
LLDP-MED: Switch
Port
Procedure
Step 1
Press Applications.
Step 2
To access the Network Settings menu, select Administrator Settings > Network Settings.
Related Topics
Text Menu Entry from Phone, on page 31
Set Up IPv4
The following table describes the IPv4 Setup menu options.
Cisco Unified IP Phone 8941 and 8945 Administration Guide for Cisco Unified Communications Manager 10.0
(SCCP and SIP)
34
Configure Network Settings

Cisco Unified IP Phone 8941 Specifications

General

Brand	Cisco
Model	Unified IP Phone 8941
Category	IP Phone
Language	English