5.3.3 Replacing the Cleaning Agent Canister
For your safety when using the appliance
Before starting work, read and understand the rules, risks, and hazards specified in “
Safely Using the
Appliance
on page 97” and follow all the corresponding instructions without exception.
Required tools
Replacement ConvoClean new or ConvoClean forte canister
Replacing the Cleaning Agent Canister
1.
Remove the cap from the ConvoClean new or
ConvoClean forte replacement canister.
2.
Find the canister that is connected to the cleaning
agent connection (G) with a (red) tube and that is
located on the bottom left side of the appliance.
Unscrew the (red) supply tube (2), together with the
wand, from the canister you just identified.
Remove the empty cleaning agent canister.
3.
Put the new, full canister (1) containing cleaning agent
in place.
Insert the (red) supply tube, together with the wand
(2), into the full canister (1) and screw it in place.
Make sure that the tube is routed without any kinks
and that the vent opening on the canister’s cap is open
and clear.
4.
Check to make sure that the canisters are set up
correctly:
The canisters’ location must be lower than the level
at which the appliance is resting on its base.
The contact point between the canisters and their
supporting surface must not be more than 40
inches below the bulkhead fittings.
Check to make sure that the tube is connected to the
right connection.
The cleaning agent must go to appliance
connection G
(indicated by a red color).
5 How to Clean the Combi Steamer
Operating Manual 100
To Next Page
Loading...
Need help?
General
