6.3.3 Replacing the oven light halogen lamp
For your safety when performing maintenance
Before starting any maintenance work, familiarize yourself with the rules, risks, and hazards specified
in “
Working Safely When Performing Maintenance
on page 123” and follow all the corresponding
instructions without exception.
Procedures that you must be familiar with
You will need to be familiar with the following steps:
Safely Opening and Closing the Appliance Door 60
Spare parts included
As indicated in the spare parts list, the required spare part is:
One (1) 12 V halogen lamp
Required tools
You will need the following tools:
Socket wrench with a width across flats of 8 mm
Handling the halogen lamp
Always wear clean gloves when grabbing halogen lamps (alternatively, you can use a cloth). Do not
touch the bulb in new halogen lamps, or halogen lamps that you will be reusing, with your bare fingers.
If the halogen lamp cannot be removed completely, e.g., the terminals are stuck, contact a service
technician immediately.
Prerequisites
Check whether the following prerequisites are met:
The combi steamer has been de-energized and locked and tagged out.
The cooking compartment must have cooled down to a temperature of less than 140 °F since the
last time it was used.
The loading trolley must have been removed from the cooking compartment.
The halogen lamp has already cooled down.
The new halogen lamp has been inspected for damage and is not damaged.
6 How to Perform Maintenance on the Combi Steamer
Operating Manual 125
To Next Page
Loading...
Need help?
General
