DIR-620 Wireless N300 Router with 3G/CDMA/LTE Support
and USB Port
User Manual
Configuring via Web-based Interface
MAC Filter
On pages of the Wi-Fi / MAC Filter section, you can define a set of MAC addresses of devices
which will be allowed to access the WLAN, or define MAC addresses of devices which will not be
allowed to access the WLAN.
Figure 120. The page for configuring the MAC filter for the wireless network.
By default, MAC filtering is not active (the Disabled value is selected from the MAC filter
restrict mode drop-down list on the Wi-Fi / MAC Filter / Filter mode page).
To open your wireless network for the devices which MAC addresses are specified on the Wi-Fi /
MAC Filter / MAC addresses page and to close the wireless network for all other devices, select
the Allow value from the MAC filter restrict mode drop-down list and click the Apply button.
To close your wireless network for the devices which MAC addresses are specified on the Wi-Fi /
MAC Filter / MAC addresses page, select the Deny value from the MAC filter restrict mode
drop-down list and click the Apply button.
To add a MAC address to which the selected filtering mode will be applied, proceed to the Wi-Fi /
MAC Filter / MAC addresses page.
Page 145 of 225
To Next Page
Loading...
Need help?
General
