DIR-620 Wireless N300 Router with 3G/CDMA/LTE Support
and USB Port
User Manual
Configuring via Web-based Interface
Remote Update
!
Attention! Do not turn off the router before the firmware upgrade is completed. This may
cause the device breakdown.
To update the firmware of the router remotely, follow the next steps:
1. On the System / Firmware upgrade page, in the Remote update section, click the
Check for updates button to check if a newer firmware version exists.
2. Click the OK button in the window displayed to upgrade the firmware of the router. Also
you can upgrade the firmware of the router by clicking the Remote update button (the
button is displayed if a newer version of the firmware is available).
3. Wait until the router is rebooted (about one and a half or two minutes).
4. Log into the web-based interface using the login (admin) and the current password.
After the upgrade is completed, the new version of the firmware will be displayed in the top left
corner of the page.
If after updating the firmware the router doesn't work correctly, please restore the factory default
settings. To do this, place the mouse pointer over the System caption in the top left corner of the
page and click the (Reset to factory) icon. Wait until the router is rebooted.
Page 213 of 225
To Next Page
Loading...
Need help?
General
