D-Link Web Smart Switch DGS-1210-16 User Manual

Command Line Interface D-Link Web Smart Switch User Manual
9
9
4
4
DGS-1210-24:admin#upload firmware_toTFTP 10.90.90.10 RUNTIME
Connecting to server................... Done.
Upload firmware........................ Done.
DGS-1210-24:admin#
config ipif System
Purpose This command is used to configure the System IP interface.
Syntax
config ipif System {ipaddress <ip-address> <subnet-mask>
gateway <gw-address> | dhcp | bootp}
Description
The config ipif S ys tem
command configures the System IP
interface on the Switch.
Parameters
ipaddress <ip-address> <subnet-mask> − Specifies the IP address
and subnet mask to be created. Users need to specify the IP
address and subnet mask information using the traditional format
(For example, 10.1.2.3/255.0.0.0).
gateway <gw-address> − Specifies the IP address of the router or
gateway.
dhcp −
Allows the selection of the DHCP protocol for the
assignment of an IP address to the Switch’s System IP interface.
bootp − Allows the selection of the BOOTP to the Switch.
Restrictions None.
Example usage:
To configure the IP interface System:
DGS-1210-24:admin#config ipif System ipaddress 10.90.90.2 255.0.0.0 gateway
10.90.90.1
Success.
DGS-1210-24:admin#
logout
Purpose This command is used to logout a user from the Switch’s
Command Line Interface.
Syntax
logout
Description
The logout command terminates the current user’s session from
the Switch’s console.
Parameters None.
Restrictions None.
Example usage:
To terminate the current user’s console session:

D-Link Web Smart Switch DGS-1210-16 Specifications

General

Brand	D-Link
Model	Web Smart Switch DGS-1210-16
Category	Switch
Language	English