Configuration D-Link Web Smart Switch User Manual
8
8
3
3
Figure 4.97 – SNMP > SNMP > SNMP User Table
User Name: Enter a SNMP user name of up to 32 characters.
Group Name: Specify the SNMP group of the SNMP user.
SNMP Version: Specify the SNMP version of the user. Only SNMPv3 encrypts the messages.
Encrypt: Specifies the Encrypt is enabled or disabled when the SNMP Version is V3.
Auth-Protocol/Password: Specify either MD5 or SHA to be the authentication protocol. Enter a password
for SNMPv3 encryption in the right column.
Privacy Protocol/Password: Specify either none or DES and then enter a password for SNMPv3
encryption in the right column.
Click Add to create a new SNMP user account. Click Delete to remove the corresponding entry.
This window is used to maintain the SNMP Group Table associating to the users in SNMP User Table.
SNMPv3 can control MIB access policy, security policy for a user group directly.
SNMP > SNMP > SNMP Group
Figure 4.98 – SNMP > SNMP > SNMP Group
Group Name: Specify the SNMP user group of up to 32 characters.
Read View Name: Specify a SNMP view name for users that are allowed SNMP read privileges to the
Switch's SNMP agent.
Write View Name: Specify a SNMP view name for users that are allowed SNMP write privileges to the
Switch's SNMP agent.
Security Model: Select the SNMP security model.
v1 – SNMPv1 does not support the security features.
To Next Page
Loading...
Need help?
General