Configuration D-Link Web Smart Switch User Manual
8
8
5
5
Community Name: Type an alphanumeric string of up to 32 characters that is used to identify members of
an SNMP community. This string is used like a password to give remote SNMP managers access to MIB
objects in the Switch’s SNMP agent.
User Name (View Policy): Specifies that the SNMP community string will be created with privileges that can
either be ReadOnly or ReadWrite. Alternatively, an existed user name can be selected that will be used
together with the community string. The privileges will depend on the SNMP user that was created.
Click Add to create a new SNMP community. Click Delete to remove the corresponding entry.
This SNMP Host window is used to configure the SNMP trap recipients.
SNMP > SNMP > SNMP Host
Figure 4.101 – SNMP > SNMP > SNMP Host
Host IP Address: Specifies the IP address of SNMP management host.
SNMP Version: Select the SNMP version to be used to the management host.
Community String/SNMPv3 User Name: Specifies the community string or SNMPv3 user name for the
management host.
Click Add to create a new SNMP host. Click Delete to remove the corresponding entry.
The Engine ID is a unique identifier used to identify the SNMPv3 engine on the Switch.
SNMP > SNMP > SNMP Engine ID
Input the Engine ID then click Apply to apply the changes and click Default resets to default value.
Figure 4.102 – SNMP > SNMP > SNMP Engine ID
Users can enable and disable remote monitoring (RMON) status for the SNMP function on the Switch. Click
Apply to make effects.
SNMP > RMON > RMON Global Settings
Figure 4.103 – SNMP > RMON > RMON Global Settings
The RMON Statistics Configuration window displays the information of RMON Ethernet Statistics and allows
the user to configure the settings.
SNMP > RMON > RMON Statistics
To Next Page
Loading...
Need help?
General