D-Link Web Smart Switch DGS-1210-16 - Download

Command Line Interface D-Link Web Smart Switch User Manual
9
9
2
2
Command Parameter
reboot
reset config
show ipif
show switch
config account admin
password
<password>
save
debug info
Each command is listed in detail, as follows:
?
Purpose This command is used to display a list of commands.
Syntax
?
Description
The ? command displays a list of commands of the Switch.
Parameters None.
Restrictions None.
Example usage:
To display a list of commands of the Switch:
DGS-1210-24:admin#?
USEREXEC commands :
config account admin password <password>
config ipif System { ipaddress <ip-address> <subnet-mask> gateway <gw-
address>|
dhcp | bootp}
debug info
download { firmware_fromTFTP | cfg_fromTFTP} <ipaddr> <path_filename 64>
logout
ping <ipaddr>
reboot
reset config
save
show ipif
show switch
upload { firmware_toTFTP | cfg_toTFTP} <ipaddr> <path_filename>
DGS-1210-24:admin#
download
Purpose This command is used to download and install a firmware file, boot
file, or switch configuration file from a TFTP server.