MNL-00008 [5] Proprietary and Confidential Page 21 of 55
16.4.2 Setting Up a Treatment Time
To administer a treatment, you must enter your desired treatment time. Based on the example
above the treatment time will be 1:10.
1. After unlocking device, tap the “Treat Patient” button.
2. Touch the ▲/▼ arrows to set desired Treatment Time
3. Tap the Enter Arrow to enter Treatment Confirmation screen.
4. Ensure patient has put on goggles and positioned themselves per the instructions.
5. Confirm Treatment Time.
• If Treatment Time is correct, tap Enter Arrow to begin treatment.
• If changes need to be made to Treatment Time, tap Return Arrow to return to
step #2.
6. Following delayed start, if enabled, treatment will begin, and screen will display
progress.
To repeat the same dose for another exposure, touch the Repeat button
Note: The system beeps to signal the end of the treatment and displays the delivered dose
with the elapsed time.
16.4.3 Special Functions of the Integrated Dosimeter
• To pause an active treatment, tap the Pause button
• To resume a paused treatment, tap the Play button
• To end or cancel an active treatment, first pause the treatment and then tap the Cancel
button
16.4.4 Special Notes
• It is not possible to enter a time of 60 seconds. You must enter 1 minute instead.
• If power goes off during a treatment, the system will remember how much of the
treatment has elapsed. When power is restored, your device provides option to resume
interrupted treatment.
16.4.5 Timer Range and Accuracy
To Next Page
Loading...
Need help?
General
