Daikin 2AMX40G3V1B User Manual

SA Indoor Unit SiBE121123_A
133 Remote Controller
2.3 BRC7E530W
8
10
13
11
12
15
14
16
17
9
1
3
4
6
2
5
7
DOWN
FAN
UP
ON OFF
MHL
C
hr.
hr.
TEST
MODE
TIMER
RESERVE
CANCEL
DOWN
UP
TEST
SWING
FAN
TIME
TEMP
ON
OFF
MHL
C
hr.
hr.
TEST
(R17880)
21
20 22
23
19
18
(R17873)
1
2
3
4
5
6
7
8
9
H • L • M
˚C
hr.
hr.
10
13
14
15
16
17
18
19
20
21
22
23
DISPLAY “ ” (SIGNAL TRANSMISSION)
DISPLAY “ ” “ ” “ ” “ ” “ ”
(OPERATION MODE)
DISPLAY “ ” (SET TEMPERATURE)
DISPLAY “ ”
(PROGRAMMED TIME)
DISPLAY “ ” (AIR FLOW FLAP)
DISPLAY “ TEST” (INSPECTION/
TEST OPERATION)
DISPLAY “ ” “ ” (FAN SPEED)
ON/OFF BUTTON
FAN SPEED CONTROL BUTTON
TEMPERATURE SETTING BUTTON
Press the button and the system will start.
Press the button again and the system will stop.
Press this button to select the fan speed,
HIGH or LOW, of your choice.
Use this button for SETTING
TEMPERATURE (Operates with the front
cover of the remote controller closed.)
TIMER RESERVE/CANCEL BUTTON
AIR FLOW DIRECTION ADJUST BUTTON
OPERATION MODE SELECTOR BUTTON
FILTER SIGN RESET BUTTON
INSPECTION/TEST OPERATION BUTTON
EMERGENCY OPERATION SWITCH
RECEIVER
OPERATING INDICATOR LAMP (Red)
TIMER INDICATOR LAMP (Green)
DEFROST LAMP (Orange)
AIR FILTER CLEANING TIME
INDICATOR LAMP (Red)
This lamp stays lit while the timer is set.
Lights up when it is time to clean the air filter.
Lights up when the defrosting operation
has started. (For straight cooling type this
lamp does not turn on.)
This lamp stays lit while the air conditioner
runs. It flashes when the unit is in trouble.
Press this button to select OPERATION MODE.
This button is used only by qualified service
persons for maintenance purposes.
This switch is readily used if the remote
controller does not work.
This receives the signals from the remote controller.
This lights up when a signal is being
transmitted.
This display shows the current
OPERATION MODE. For straight cooling
type, “ ” (Auto) and “ ” (Heating) are
not installed.
This display shows the set temperature.
This display shows PROGRAMMED TIME
of the system start or stop.
The display shows the set fan speed.
When the INSPECTION/TEST
OPERATION BUTTON is pressed, the
display shows the system mode is in.
11
12
Use this button for programming “START
and/or STOP” time. (Operates with the front
cover of the remote controller opened.)
PROGRAMMING TIMER BUTTON
TIMER MODE START/STOP BUTTON

Daikin 2AMX40G3V1B Specifications

General

Brand	Daikin
Model	2AMX40G3V1B
Category	Air Conditioner
Language	English