SiBE041101 Operation Manual
Operation Manual 64
2.9 ON TIMER Operation
22
ON TIMER Operation
To use ON TIMER operation
1. Press .
• “ ” and setting time are displayed on the LCD.
• “ ” is displayed on the LCD.
• “ ” blinks.
2.
3. Press again.
• The TIMER lamp lights up.
To cancel ON TIMER operation
4. Press .
• “ ” and setting time disappear from the LCD.
• “ ” and day of the week are displayed on the LCD.
• The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the 2 timers is shown below.
NOTE
In the following cases, set the timer again.
(Example)
Present time: 23:00
(The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
Display
• Check that the clock is correct. If not, set the clock to the
present time.
Press until the time setting reaches
the point you like.
• Each pressing of either button increases or decreases
the time setting by 10 minutes. Holding down either
button changes the setting rapidly..
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
To Next Page
Loading...
Need help?
General
