To Next Page

To Previous Page

40 Printer and Laminator Settings

Closing the Status Monitor

ToclosetheStatusMonitor:

1. ClicktheredClosebutton.

2. Apromptdisplays,askingifyouwanttoclosetheStatusMonitor.ClickYes.

TipsforSuccess

 WhenyouclosetheStatusMonitor,communicationbetweentheprinterand

driverbecomesoneway,withtheprinterdriversendingcardstotheprinter.

 TokeeptheStatusMonitorrunningwithoutviewingit,clickMinimize.

Printer Status Tab

ThePrinterStatustabdisplays:

 Thetypeofinkribbonandtheapproximatepercentage

remaining.

 Thetypeofretr ansferfilmandtheapproximate

percentageremaining.

 TheprintcounterandaClearbuttontoresetittozero.

 Theprintername.Ifmorethanoneprinterisinstalled,

selecttheprintertoworkwithusingthePrinterSelection

list.ClickUpdatetosearchforadditionalSR200&SR300

printers.TheinformationdisplayedontheStatusMonitor

changesautomaticallywhenyouselectanotherprinter:

 IfthePCisnetwork‐connected,onlyprintersonthe

samesubnetasthePCcanbefound.

 IfthePCisUSB‐connected,allprintersconnectedtothePCwillbefound.

 CardQuantity:Enoughisdisplayedwhencardsarepresentinthehopper.Nonedisplays

whennocardsarepresent.

 Iftheprinterisprocessingajob,thenameofthedocumentandthenameof

theuserdisplaysintheDocumentInformationarea.

 Whentheprinterrequirescleaning,theprinterimagedisplaysCleaning:

 Ifalaminatorisattached,laminatorstatusdisplaysundertheprinterstatus

(markedbytherectangle).

 Thecurrentstateoftheprinter,suchasReady. Theiconchangescolorwithdifferentstates.

Refertothefollowingtable:

DataCard SR300 User Manual

Other manuals for DataCard SR300