Enter/Exit Programming Mode
204
PowerScan™ PD953X/PBT950X/PM950X
Motionless Timeout
Specifies the waiting time in 100 millisecond ticks to assume that the reader
is in a motionless condition. The selectable range is 500 msec to 25.5 Sec-
onds. When no motion event is detected for a period of time longer than this
timeo
ut, the software assumes the reader is in a motionless condition. This
option relates to such features as Aimer On and Stand Mode Object Sense
scanning with respect to motion. See "Moti
onless Timeout" on page 301 in
References.
Select Motionless Timeout Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by three digits from the Alpha-
numeric characters in
Appendix D, Keypad
rep-
resenting your desired character(s). End by scanning
the ENTER/EXIT ba
r code again.
Make a mistake? Scan the CANCEL bar code to abort
an
d not save the entry string. You can then start
again at the beginning.
CANCEL
020 = Motionless Timeout = 2 seconds
To Next Page
Loading...
Need help?
General
