Customizing Configuration Settings
Product Reference Guide
17
Customizing Configuration Settings
Configure Interface Settings
If after scanning the interface bar code from the previous table, your instal-
lation requires you to select options to further customize your reader, turn
t
o the appropriate section for your interface type in "Configuration Parame-
ters" st
arting on page 21.
Global Interface Features
See "Global Interface Features" on page 23 for settings configurable by all
interface types.
Configuring Other Features
If your installation requires different programming than the standard factory
default settings, the following sections of this manual allow configuration of
non-interface-specific settings you might require. Go to Configuration
Using Bar Codes, starting on page 21 for a complete list of available options.
Software Version Transmission
The software version of the device can be transmitted over the RS-232 and
Keyboard interfaces by scanning the following label.
Transmit Software Version
Resetting the Product Configuration to Defaults
Restore Custom Defaults
If you aren’t sure what programming options are in your imager, or you’ve
changed some options and want to restore the Custom Default Configura-
tion that may have been saved in the scanner, scan the Restore Custom
De
fault Configuration bar code below. This will restore the custom configu-
ration for the currently active interface.
Custom defaults are based on the interface type. Configure the imager
for the correct interface before scanning this label.
Restore Custom Default Configuration
Restore Factory Configuration
The "Restore Custom Default Configuration" command above is normally
enough to restart the machine from a known status (set in the factory or by
the customer via configuration file). The machine is set as it arrived to you
from the factory or according to the custom configuration file you loaded
afterward.
If you want to
permanently cancel the setup defined by the configuration
file use "Restore Factory Configuration" on page 336 of this manual.
The programming items listed in the following sections show the factory
de
fault settings for each of the menu commands. If no configuration file has
been loaded, the above command restores the factory default.
To Next Page
Loading...
Need help?
General
