Enter/Exit Programming Mode
82
PowerScan™ PD953X/PBT950X/PM950X
Default settings are indicated at each feature/option with a green arrow.
Also reference Appendix C, Standard Defaults for a listing of the most
widely used set of standard factory settings.
To set most features:
1. Scan the ENTER/EXIT PROGRAMMING bar code at the top of applicable
programming
pages.
2. Scan the correct bar code to set the
desired programming feature or
parameter. You may need to cover unused bar codes on the page, and
possibly the facing page, to ensure that the reader reads only the bar
code you intend to scan.
3. If additional input parameters ar
e needed, go to Appendix D, Keypad,
and scan the appropriate characters from the keypad.
Additional information about many features can be found in the “Ref-
erences” chapter.
If you make a mistake before the last character, scan the CANCEL bar
co
de to abort and not save the entry string. You can then start again
at the beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT
PROGRAMMING bar code to exit Programming Mode.
CODABAR on page 138
ABC CODABAR on page 144
CODE 11 on page 147
GS1 DATABAR™ OMNIDIRECTIONAL on page 151
GS1 DATABAR™ EXPANDED on page 152
GS1 DATABAR™ LIMITED on page 157
CODE 93 on page 158
MSI on page 163
PLESSEY on page 168
GS1-128 on page 119
To Next Page
Loading...
Need help?
General
