Enter/Exit Programming Mode
Product Reference Guide
257
Set String Terminator
Sets the terminator of the predefined strings.
Set String Terminator
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left
followed by 32 digits from the Alphanumeric
characters in
Appendix D, Keypad.
The digits must be the hexadecimal ASCII representa-
tion of the desired characters. If less than the
ex
pected string of 16 characters are selected, scan the
ENTER/EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End by
scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code t
o abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
To Next Page
Loading...
Need help?
General
