Datalogic PowerScan PD953X User Manual

Enter/Exit Programming Mode
252 PowerScan™ PD953X/PBT950X/PM950X
ACTION CONFIGURATION FOR FUNCTION KEYS
Configure actions (up to three) for the function keys
Configure Actions for F1
DEFAULT
$CPWEV0000\r
F1 No Actions Configured
$CPWEV
Configures Action for F1
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
for
the Function Key you want to program. Next scan
4 digits from the Alphanumeric characters in
Appen-
dix D, Keypad .
The first digit must be 0; the following 3 digits must
be confi
gured according to the CMD_ID numbers in
Table 27 on page 251 . End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL
bar code to abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL
DEFAULT
$CPWET0000\r
Configure Actions for F2
F2 No Actions Configured

Datalogic PowerScan PD953X Specifications

General

Brand	Datalogic
Model	PowerScan PD953X
Category	Barcode Reader
Language	English