Product Reference Guide
25
RS-232 ONLY INTERFACE
BAUD RAT E on page 26
DATA BITS on page 27
STOP BITS on page 27
PARITY on page 28
HANDSHAKING CONTROL on page 29
Use the programming bar codes in this section if modifications to the stan-
dard RS-232 interface settings are necessary to meet your system’s require-
ments. Additional settings which apply to both the
RS-232 and USB
interfaces are available in the next section, "RS-232/USB-Com Interfaces"
starting on page 30.
Reference Appendix C, Standard Defaults for a listing of standard factory
settings.
To Next Page
Loading...
Need help?
General
