Dell Embedded Box PC5000 Service Manual

Removing the power connectors
WARNING: Before working inside your Embedded Box PC, read the safety
information that shipped with your Embedded Box PC and follow the steps
in Before working inside your Embedded Box PC. After working inside your
Embedded Box PC, follow the steps in After working inside your Embedded
Box PC. For more safety best practices, see the Regulatory Compliance
home page at www.dell.com/regulatory_compliance.
Prerequisites
1 Follow step 1 to step 6 in “Removing the back cover”.
2 Remove the PCI/PCIe card (if installed).
3 Remove the heat sink.
Procedure
1 Remove the nut and washer that secure the barrel connector to the chassis.
2 Push the barrel connector through the slot chassis.
3 Remove the screw that secures the grounding cable to the system board.
4 Disconnect the power cable from the system board.
105

Dell Embedded Box PC5000 Specifications

General

Brand	Dell
Model	Embedded Box PC5000
Category	Computer Hardware
Language	English