Steps
1. Place the power-adapter port, along with the cable, in the slot on the palm-rest and keyboard assembly.
2. Route the power-adapter port cable through the routing guide on the palm-rest and keyboard assembly.
3. Connect the power-adapter port cable to the connector on the system board.
4. Adhere the tape to secure the power-adapter port cable to the connector on the system board.
5. Close the right display hinge downwards to align the screw holes on the right display hinge to the screw holes on the system
board and the palm-rest and keyboard assembly.
6. Replace the two screws (M2.5x3.5) to secure the right display hinge to the system board and the palm-rest and keyboard
assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
I/O daughter-board cable
Removing the I/O daughter-board cable
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following images indicate the location of the I/O daughter-board cable and provide a visual representation of the removal
procedure.
Removing and installing Field Replaceable Units (FRUs)
61
To Next Page
Loading...
Need help?
General