Dell PowerEdge R810 User Manual

114 Installing System Components
Figure 3-15. Installing a NIC Hardware Key
5 Close the system. See "Closing the System" on page 85.
6 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
Expansion Cards and Expansion-Card Risers
Expansion Card Installation Guidelines
Your system supports up to six Generation 2 PCIe expansion cards installed in
connectors on the system board and two expansion-card risers. To locate the
expansion-card connectors on the system board, see
Figure 6-1 and to locate
the
expansion-card connectors on the expansion-card risers, see Figure 6-4 and
Figure 6-5.
The following are the slot configurations on the risers and the system board:
1 NIC hardware key 2 ISCSI KEY connector
2
1
book.book Page 114 Thursday, February 18, 2010 2:06 PM

Dell PowerEdge R810 Specifications

General

Form Factor	2U rack server
Chipset	Intel 7500 chipset
Memory Slots	32 DIMM slots
Processor	Up to four Intel Xeon 6500/7500 series processors
Memory	Up to 512GB (32 DIMM slots): 1GB/2GB/4GB/8GB/16GB DDR3
Storage	Up to six 2.5" SAS or SATA drives
RAID Controller	PERC H700, PERC H800
Network	Four embedded Broadcom NetXtreme II 5709c Gigabit Ethernet NICs
Power Supply	Redundant 1100W or 750W AC power supplies
Expansion Slots	6 x PCIe Gen2 slots (3 x x8, 3 x x16)
Operating System Support	Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi