Configuration: Disk Groups and Virtual Disks 149
NOTE: You cannot mix different media types or different interface types
within a single disk group or virtual disk.
5
Click
Add
.
A message prompts you to confirm your selection.
6
To add the capacity to the disk group, click
Yes
.
You can also use the Command Line Interface (CLI) on both Windows and
Linux hosts to add free capacity to a disk group.
After the capacity expansion is completed, additional free capacity is available
in the disk group for creation of new virtual disks or expansion of existing
virtual disks.
Virtual Disk Expansion
Virtual disk expansion is a dynamic modification operation that increases the
capacity of standard virtual disks.
NOTE: Snapshot repository virtual disks can be expanded from the CLI or from
MDSM. All other virtual disk types are expandable only from the CLI.
If you receive a warning that the snapshot repository virtual disk is becoming
full, you may expand the snapshot repository virtual disk from MDSM. See
"Snapshot Repository Capacity" on page 169 for step-by-step instructions.
Using Free Capacity
You can increase the capacity of a virtual disk using the free capacity on the
disk group of the standard virtual disk or the snapshot repository virtual disk.
The Free Capacity node, shown in the Logical pane, is a contiguous region of
unassigned capacity on a defined disk group. When increasing virtual disk
capacity, some or all of the free capacity may be used to achieve the required
final capacity. Data on the selected virtual disk remains accessible while the
process for increasing virtual disk capacity is in progress.
Using Unconfigured Capacity
You can increase the capacity of a standard virtual disk or a snapshot
repository virtual disk using the unconfigured capacity when no free capacity
exists on a disk group. An increase is achieved by adding unconfigured
book.book Page 149 Tuesday, September 27, 2011 3:13 PM
To Next Page
Loading...
Need help?
General