Troubleshooting: Your Storage Array Software 259
Finding Nodes
You can use the Find option to search for a particular node on the Logical
tab, the Physical tab, or the Mappings tab of the AMW. The search may be
based on a particular node name, the RAID level, virtual disk capacity, or
specific free capacity nodes. The search may be based also on one of these
combinations:
• The node name and the RAID level
• The node name and the virtual disk capacity
To find nodes:
1
In the AMW, select
View
ï‚®
Find
.
2
Based on the type of search, select one of these options, and go to the
indicated step:
• Search by name—see step 3.
• Search by special criteria—see step 4.
3
Type the name of the node to be found in
Find Node
. See step 8.
4
Based on the search criteria, select one of these options, and go to the
indicated step:
• Find all virtual disks with RAID level—Go to step 5.
• Find all virtual disks with capacity—Go to step 6.
• Find all free capacity nodes—Go to step 7.
5
To search for all nodes based on their RAID level, perform these steps:
a
Select
Find all virtual disks with RAID level
.
b
Select the RAID level from the list.
c
Go to step 8.
6
To search for all nodes based on their virtual disk capacity, perform these
steps:
a
Select
Find all virtual disks with capacity
.
b
Type the capacity in the
GB
box.
c
Specify that the capacity to be matched is less than, equal to, or
greater than the capacity entered in the
GB
box.
d
Go to step 8.
book.book Page 259 Tuesday, September 27, 2011 3:13 PM
To Next Page
Loading...
Need help?
General