Dell PowerVault MD3620i User Manual

Configuration: About Your Storage Array 79
Configuring Alert Notifications
MDSM can send an alert for any condition on the storage array that requires
your attention. Alerts can be sent as e-mail messages or as Simple Network
Management Protocol (SNMP) trap messages.
You can configure alert notifications either for all the storage arrays or a single
storage array.
To configure alert notifications for all storage arrays:
1
In the EMW, select the Setup tab.
2 Select Configure Alerts .
The
Configure Alerts dialog is displayed.
3 Select All storage arrays .
4 Click OK .
The
Configure Alerts dialog is displayed. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 79. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 82.
To configure alert notifications for a single storage array:
1
In the EMW, select the Devices tab.
2 Select the relevant storage array, then select Edit  Configure Alerts .
The
Configure Alerts dialog is displayed. To configure e-mail alerts, see
"Configuring E-mail Alerts" on page 79. To configure SNMP alerts, see
"Configuring SNMP Alerts" on page 82.
Configuring E-mail Alerts
For more information on configuring alert notifications, see "Configuring
Alert Notifications" on page 79.
To configure e-mail alerts:
1
Open the Configure Alerts dialog by performing one of these actions:
• In the tree view or the table view on the
Devices tab in the EMW,
select a node, and then select
Edit  Configure Alerts . Go to step 3.
•In the
Setup tab in the EMW, select Configure Alerts . Go to step 2.
2 Select one of the following radio buttons to specify an alert level:
book.book Page 79 Tuesday, September 27, 2011 3:13 PM

Dell PowerVault MD3620i Specifications

General

Brand	Dell
Model	PowerVault MD3620i
Category	Storage
Language	English