105
7-3. Setting the Volume Control
• Set the upper limit for the volume, the volume level when the power is turned on, and the volume level when the mute mode is set for the
different zones.
1
Select “Volume Control” at the Option Setup menu.
2
Display the Volume Control screen.
Volume Control
*Option Setup
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
3
q Select the desired setting.
w Select the parameter.
Volume Limit: Set the upper limit for the volume for the different zones.
–20 dB, –10 dB, 0 dB : The volume cannot be increased above the selected levels.
OFF : If you do not want to set a volume limit, select “OFF”.
In this case, the volume can be set to the AVC-A1XVA’s maximum volume (output) level of +18 dB, which is
extremely loud.
Power On Level: Set the volume that is set when the power is turned on for the different zones.
You can adjust the volume level within the range of –80 to +18 dB in steps of 1.0 dB.
– – – (Mute) : The volume is always muted when the power is turned on.
LAST : The volume set when the AVC-A1XVA was last used is stored in the memory and set when the power is turned
on.
Mute Level: Set the volume attenuation level when the mute mode is set for the different zones.
FULL : The volume is fully muted.
–40 dB : The volume is lowered 40 dB from the current level.
–20 dB : The volume is lowered 20 dB from the current level.
Volume Level: Set whether to fix the output level for the different zones or make it variable.
Variable : The level can be adjusted freely using buttons on the Remote control unit.
–40 dB, 0 dB : The output level is fixed at the set level and the volume can no longer be adjusted.
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
Make the volume restriction settings for the different zones.
NOTES:
• For ZONE2, ZONE3 and ZONE4, the “Volume Limit”, “Power On Level” and “Mute Level” can be set when “Variable” is
selected for “Volume Level”.
• When the power amplifier is assigned to either of the ZONE2, ZONE3 and ZONE4 channels at “7-2. Power Amp Assign”, “-VAR-
” (only variable) is displayed and the fixed level cannot be set.
To Next Page
Loading...
Need help?
General
