120
Operating a component stored in the preset memory
1
2
Press the mode selector button for the component you want
to operate.
Operate the component.
For details, refer to the component’s operating
instructions.
Some models cannot be operated with this remote control
unit.
1. DVD player (DVD), DVD recorder (DVDR) system buttons 2. Satellite (SAT) tuner, cable (CABLE) system buttons
SRC ON : Power on
SRC OFF : Power off
SETUP : Setup
DISP : Guide
MENU : Menu
•
,
ª
,
00
,
11
: Cursor up, down, left and right
ENTER : Enter
CH +, – : Switch channels +, –
0 ~ 9, +10 : Number
SRC ON : Power on
SRC OFF : Power off
6, 7 : Manual search
(forward and reverse)
2 : Stop
1 :Play
8, 9 :Auto search
(to beginning of track)
3 : Pause
SETUP : Setup
MENU : Menu
•
,
ª
,
00
,
11
: Cursor up, down, left and right
ENTER : Enter
DISP : Display
CH +, – : Switch channels +, –
0 ~ 9, +10 : Number
Default setting = DVD
The preset codes of a DVDR can be recorded in the DVD mode so
that the DVD recorder can be operated. (See page 119)
It is only possible to set the preset memory for either the DVD or
DVDR.
When there are codes usable for the preset device, those codes
are sent when the buttons below are pressed. If not, by default the
DVD codes are punched through. If the punch through setting is
made after the preset memory is set, the codes are sent with
priority.
6, 7 : Manual search (forward and reverse)
2 : Stop
1 :Play
8, 9 : Auto search (cue)
3 : Pause
Default setting = SAT
The preset codes of a CABLE can be recorded in the SAT/CBL mode
so that the cable device can be operated. (See page 119)
It is only possible to set the preset memory for either the SAT or
CBL.
NOTE:
• For the DVD player remote control buttons, function names may
differ according to manufacturer. Compare with the remote
control operation of the various components.
To Next Page
Loading...
Need help?
General
