Overview Hardware specifications for programmable variant
XBee/XBee-PRO ZigBee RF Modules User Guide 12
Hardware specifications for programmable variant
The following specifications need to be added to the current measurement of the previous table if the module
has the programmable secondary processor. For example, if the secondary processor is running and constantly
collecting DIO samples at a rate while having the RF portion of the XBee sleeping the new current will be I
total
= I
r2
+ I
0
, where I
r2
is the runtime current of the secondary processor and I
s
is the sleep current of the RF portion of the
module of the XBee-PRO (S2B) listed in the table below.
I/O interface 3.3 V CMOS UART (not 5 V
tolerant), DIO, ADC
3.3 V CMOS UART (not 5 V tolerant),
DIO, ADC
3.3 V CMOS UART (not 5 V
tolerant), DIO, ADC
Networking and Security
Supported network
topologies
Point-to-point, point-to-
multipoint, peer-to-peer, and
mesh
Point-to-point, point-to-multipoint,
peer-to-peer, and mesh
Point-to-point, point-to-
multipoint, peer-to-peer, and
mesh
Number of
channels
16 direct Sequence channels 14 Direct sequence channels 15 Direct sequence channels
Channels 11 to 26 11 to 24 11 to 25
Addressing options PAN ID and addresses, cluster
IDs and endpoints (optional)
PAN ID and addresses, cluster IDs
and endpoints (optional)
PAN ID and addresses, cluster
IDs and endpoints (optional)
Agency Approvals
United States (FCC
Part 15.247)
FCC ID: OUR-XBEE2 FCC ID: MCQ-XBEEPRO2 FCC ID: MCQ-PROS2B
Industry Canada
(IC)
IC: 4214A-XBEE2 IC: 1846A-XBEEPRO2 IC: 1846A-PROS2B
Europe (CE) Yes Yes Yes
Australia RCM/R-NZ RCM/R-NZ RCM/R-NZ
Japan R201WW07215215
(Wire, chip, RPSMA, and U.FL
versions)
R210-101040
(PCB antenna version)
R201WW08215142 (international
variant)
Wire, chip, RPSMA, and U.FL
versions are certified for Japan. PCB
antenna version is not.
R201WW10215062
(international variant)
Brazil ANATEL: 2256-14-1209
RoHS Compliant Compliant Compliant
Specification XBee XBee-PRO (S2) XBee-PRO (S2B)
Optional Secondary Processor Specification
These numbers add to S2B specifications
(Add to RX, TX, and sleep currents depending on mode
of operation)
Runtime current for 32 k running at 20 MHz +14 mA
Runtime current for 32 k running at 1MHz +1 mA
To Next Page
Loading...
Need help?
General
