Digi XBEE2 User Manual

Agency certifications Australia/New Zealand
XBee/XBee-PRO ZigBee RF Modules User Guide 192
Labeling requirements
Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible label on the outside of
the final product enclosure must display the following text:
Contains Model XBee Radio, IC: 4214A-XBEE2
The integrator is responsible for its product to comply with IC ICES-003 - Unintentional Radiators. ICES-003 is
similar to FCC Part 15 Sub. B and Industry Canada accepts Industry Canada RSS-247 report or CISPR 22 test report
for compliance with ICES-003.
If it contains an XBee-PRO (S2) RF Module, the clearly visible label on the outside of the final product enclosure
must display the following text:
Contains Model XBee PRO Radio, IC: 1846A-XBEEPRO2
If it contains an XBee-PRO (S2B) RF Module, the clearly visible label on the outside of the final product enclosure
must display the following text:
Contains Model XBee PRO S2B Radio, IC: 1846A-PROS2B
The integrator is responsible for its product to comply with IC ICES-003 - Unintentional Radiators. ICES-003 is
similar to FCC Part 15 Sub. B and Industry Canada accepts Industry Canada RSS-247 report or CISPR 22 test report
for compliance with ICES-003.
Transmitters for detachable antennas
This radio transmitter has been approved by Industry Canada to operate with the antenna types listed in the
table above with the maximum permissible gain and required antenna impedance for each antenna type
indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that
type, are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.
Le présent émetteur radio a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne
énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne.
Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont
strictement interdits pour l'exploitation de l'émetteur.
Detachable antenna
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une
antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le
but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type
d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité
nécessaire àl'établissement d'une communication satisfaisante.
Australia/New Zealand
These modules comply with requirements to be used in end products in Australia and New Zealand. All products
with EMC and radio communications must have a registered RCM/R-NZ mark. Registration to use the compliance
mark will only be accepted from Australian or New Zealand manufacturers or importers, or their agents.
In order to have an RCM/R-NZ mark on an end product, a company must comply with a or b below.
a. Have a company presence in Australia or New Zealand.

Digi XBEE2 Specifications

General

Brand	Digi
Model	XBEE2
Category	Control Unit
Language	English