To Next Page

To Previous Page

Owner's Manual

Stereo

When the STEREO parameter is turned on, the Live FX’s outputs will be congured

for stereo operation (this is the default setting). When the Stereo parameter is

turned off, the Live FX is congured for mono operation. When congured for

mono operation, all outputs will carry the same mono-summed signal. The XLR

outputs and 1/4” stereo output will all be affected when changing this setting.

To edit the STEREO setting:

1. Press the <System> button.

2. Turn the <Edit 4> knob to turn Stereo on or off.

3. Press the ashing <System> button to exit the System Edit menu.

Preset Load

When selecting presets with the DATA encoder, this system parameter determines

whether Live FX presets are loaded using a one step or two step process. The

selectable options are:

• Auto

With this option selected, presets will automatically load as they are selected

with the <DATA> encoder.

• Manual

With this option selected, presets will require you to select the preset using

the <DATA> encoder then press the <DATA> encoder to manually load

the preset. This option is useful for eliminating accidental preset changes with

the DATA encoder. If you stop on a preset when using the Manual option

and don’t press the <DATA> encoder, the preset will revert back to the

currently active preset after approximately four seconds.

NOTE: The Preset Load parameter does not affect preset changes using the Up

and Down footswitches.

To edit the PRESET LOAD setting:

1. Press the <System> button.

2. Press the <DATA> encoder once to navigate to page 2 within the System Edit

menu.

3. Turn the <Edit 1> knob to select the desired setting.

4. Press the ashing <System> button to exit the System Edit menu.

DigiTech Vocalist Live FX User Manual

Questions and Answers: