PA Series Biofeedback and Stimulation System User Manual Introduction
18
reusable vagina sensor, pull it out and store it after cleaning and disinfection.
Attentions：
1. The reusable vagina sensor is restricted to a single patient, do not cross use it.
2. The disposable vagina sensor is for single use only, do not reuse it.
3. Please do not plug or unplug the sensor during the operation of the host.
4. The device that the sensor connects to has to conform to IEC
60601-1:2005/A1:2012.
5. The sensor should be placed by qualified personnel. The entire sensor surface
should be in good contact with the vagina when placing the sensor.
6. The sensor should not contact with wounds or scars during the treatment.
2.2.3 Rectum Sensor
The rectum sensor is reusable.
The rectum sensor is used to conduct electrical signals between the pelvic floor muscles
and the host, including pelvic floor Surface electromyography signal (SEMG) and
electrical stimulation signals.
Using methods:
1. Open the package and connect the rectum sensor to the host with the sensor
cable.
2. Insert the rectum sensor into the rectum till the end of the sensor. Select an
assessment protocol or treatment plan and start it.
3. After the assessment or treatment, disconnect the sensor from the host, pull out
the sensor and keep it after cleaning and disinfection.
Attentions：
1. The sensor is restricted to a single patient, do not cross use it.
2. Please do not plug or unplug the sensor during the operation of the host.
3. The device that the sensor connects to has to conform to IEC
60601-1:2005/A1:2012.
4. The sensor should be placed by qualified personnel. The entire sensor surface
should be in good contact with the rectum when placing the sensor.
5. The sensor should not contact with wounds or scars during the treatment.
2.2.4 Stress Probe
The stress probe is used to measure the contraction strength change of the pelvic floor
muscles.
Using methods:
To Next Page
Loading...
Need help?
General
