PA Series Biofeedback and Stimulation System User Manual Software Operations
46
Waveform/Template Size: sets the width of all waveforms/ template width in MVC
detection on the Assessment and Treatment interface.
Pressure Unit: Set the pressure unit in pressure assessment and report, the pressure
unit is cmH2O by default.
5.8.2.2 Channel Settings
Pelvic Floor: sets the corresponding channel of pelvic floor muscles in the Assessment
and Treatment interface. If the channel is not configured, it is CH1by default.
Abdomen: sets the corresponding channel of abdominal muscle on the Assessment and
Treatment interface. If the channel is not configured, then it is CH2 by default.
Gluteus (in case): sets whether to use gluteus channel, setup the corresponding channel
of gluteus in the Assessment and Treatment interface. Gluteus is not selected and its
channel is CH3 by default.
Adductor (in case): sets whether to tick adductor channel, and sets the corresponding
channel of adductor on the Assessment interface. Adductor is not selected and its
channel is CH4 by default.
5.8.2.3 Other Settings
Date Format: selects a date format in the drop-down menu. If the date format is not
configured, the date format is identical with the system time format by default.
Free Training Time: sets the free training time on the Assessment interface. If it is not
configured, then it is 2 min by default.
Phase Interval: sets the interval between treatment phases on the Treatment interface. If
it is not configured, then it is 5s by default.
Current intensity Stepping（50-100mA）：sets the current intensity stepping during
Electro-Stim, ETS and Biostim Feedback, the default value is 0.5mA.
Current intensity Stepping（0-50mA）：sets the current intensity stepping during
Electro-Stim, ETS and Biostim Feedback, the default value is 1mA.
Power Frequency Filtering：Selects “50Hz” (default) or “60Hz”, and Weak Filter
(default) and Strong Filter can be selected in the drop-down menu.
ECG Filtered：Close, Weak Filter and Strong Filter can be selected in the drop-down
menu. The ECG interference can be reduced when it is turned on.
5.8.2.4 Restoring Factory Configurations
Click the Restore Factory Config button. All configurations will restore to the system
default values.
5.8.3 Printing Settings
Click Print Settings to set up patient information, report information, report title and
To Next Page
Loading...
Need help?
General
