EDAN PA Series User Manual

PA Series Biofeedback and Stimulation System User Manual Software Operations
41
5.5.2 Custom Treatment
Figure 5-25 Custom Treatment
The Custom Treatment supports user to assemble and adjust customized protocols
referring to patient’s condition. The user can select appropriate protocol segments below,
modify the parameters and add them to the phase framework. Click the Start Treatment
button to start the treatment.
When the selection of each phase is completed, click Save As and the parameter
information interface will pop up. Edit the protocol name and parameter values, and click
Save As to save the current protocol. The protocol is available in Single Protocol of pelvic
floor treatment.
Click Single Protocol, and the single protocol selection interface will pop up. Select a
protocol, and click to return to the Custom Protocol interface, the protocol will be
automatically filled in the corresponding phase of custom protocol. Click the Start
Treatment button to start the treatment.
5.6 Postpartum Rehabilitation
Select Postpartum Rehabilitation on the main interface, select a patient in the patient
list and then enter the main interface of Postpartum Rehabilitation.
Postpartum Rehabilitation has two modes: Single Person Mode and Double Person
Mode. After clicking Start All, the software would remember the user’s choice.
In Double Person Mode, CH1 and CH2 are defaulted for Patient 1, CH3 and CH4 are
defaulted for Patient 2. Channels can work or end simultaneously by clicking the “Start

EDAN PA Series Specifications

General

Brand	EDAN
Model	PA Series
Category	Medical Equipment
Language	English