PA Series Biofeedback and Stimulation System User Manual Safety Guidance
4
4 SHOCK HAZARD–Do not attempt to connect or disconnect a power cord with
wet hands. Make sure that your hands are clean and dry before touching a
power cord.
5 SHOCK HAZARD - The power receptacle must be a three-wire grounded outlet.
Never try to adapt the three-prong plug to fit a two-slot outlet. A hospital grade
outlet is required. If the outlet has only two slots, make sure that it is replaced
with a three-slot grounded outlet before attempting to operate the system.
6 Electromagnetic Interference – Ensure that the environment in which the
device is installed is not subject to any source of strong electromagnetic
emissions, such as CT, radio transmitters, mobile phone base stations, etc.
7 Electromagnetic Interference – Do not use mobile phones nearby the device,
otherwise it may interfere with device operation.
8 Do not touch the signal input or output connector and the patient
simultaneously.
9 Accessory equipment connected to the device must be certified according to
the respective IEC/EN standards (e.g. IEC/EN 60950 for data processing
equipment and IEC/EN 60601-1 for medical equipment). Furthermore all
configurations shall comply with the valid version of the system standard
IEC/EN 60601-1. If any question, please consult our technical service
department or your local distributor.
10 Connecting any accessory or equipment to the device makes a medical system.
In that case, additional safety measures should be taken during installation of
the system, and the system shall provide:
a) Within the patient environment, a level of safety comparable to that
provided by medical electrical equipment complying with IEC/EN 60601-1,
and
b) Outside the patient environment, the level of safety appropriate for
non-medical electrical equipment complying with other IEC or ISO safety
standards.
11 Do not exceed the maximum permitted load when using multiple portable
socket-outlets to supply the system. You can refer to the label or silk-screen
for the maximum permitted load.
12 SHOCK HAZARD – Do not connect non-medical electrical equipment, which
has been supplied as a part of the system, directly to the wall outlet when the
non-medical equipment is intended to be supplied via a multiple portable
socket-outlet with a separating transformer.
WARNING
13 SHOCK HAZARD –Do not connect electrical equipment, which has not been
supplied as a part of the system, to the multiple portable socket-outlet
To Next Page
Loading...
Need help?
General
