To Next Page

To Previous Page

PREPARING FOR FIERY CONTROLLER SETUP 22

Ethernet connection

For Ethernet connections, the Fiery Controller supports Unshielded Twisted Pair (UTP)

cabling for these network speeds:

• 10BaseT: Category 3 or higher

• 100BaseTX: Category 5 or higher (4-pair/8-wire, short-length)

• 1000BaseT: Category 5e or higher (4-pair/8-wire, short-length)

TO CONNECT TO THE NETWORK

1 Power off the printer and Fiery Controller.

2 Connect the cable from the network to the network port.

3 On the Fiery Controller, make sure the power switch is in the ON position and then press the

power button.

Once the LED states 00 continuously, you may proceed to the next step.

4 Power on the printer using the main power switch on the front.

5 After the Start page prints, do the following:

• Using the Configuration page, verify that the IP address of the printer is set to

100.100.100.101. If the address is not correct, check and reseat the cable between the Fiery

Controller and the printer. For more information about printing a Configuration page, see

page 47.

• Press Services Home and then verify that the Fiery icon appears on the printer touch panel.

Other manuals for EFI Fiery

Questions and Answers:

Need help?

Do you have a question about the EFI Fiery and is the answer not in the manual?

General