EFI Fiery Configuration And Setup

SETTING UP THE PRINTER 30
EFI WorkCentre Config
EFI WorkCentre Config (available on the User Software DVD) includes the following tabs:
•
SNMP allows you to configure the Fiery Controller to use the proper SNMP version and
security settings when the SNMP version and security settings are changed on the printer.
•
Admin: allows you to set the printer Administrator password.
SNMP
When the SNMP version and security settings are changed on the printer, use the SNMP tab
to configure the Fiery Controller to use the proper SNMP version and security settings. This
may be required for proper retrieval of values from the printer and affects Command
WorkStation and the printer drivers.
TO CONFIGURE THE FIERY CONTROLLER FOR SNMP
1 Make sure that no jobs are printing or processing on the Fiery Controller.
The last step of this procedure causes the Fiery Controller to reboot. Therefore, any jobs that
are being processed or printed are lost.
2 On the User Software DVD, navigate to EFI WorkCentre Config and double-click the EFI-
Workcentre-Config.exe file.
3 Choose the printer series from the drop-down list, enter the Fiery Controller IP address or
Server Name, or click Search to select the Fiery Controller in your local network, and then
click OK.
4 Click the SNMP tab.
5 Choose the SNMP version and specify the following, depending on your selection:
For SNMPv1/2c, specify the GET Community Name and the SET Community Name.
For SNMPv3, specify the Authentication Password and the Privacy Password.
6 Click Configure and type the Fiery Controller Administrator password.
7 Click Yes.
The Fiery Controller reboots.

EFI Fiery Specifications

General

Brand	EFI
Model	Fiery
Category	Server
Language	English