Projector Lamp Maintenance
208
gg Related Links
• "Replacing the Lamp" p.208
• "Resetting the Lamp Timer" p.211
• "Projector Specifications" p.241
Replacing the Lamp
You can replace the lamp while the projector is placed on a table or mounted
to the ceiling.
Warning
• Let the lamp fully cool before replacing it to avoid injury.
• Never disassemble or modify the lamp. If a modified or disassembled lamp is
installed in the projector, it could cause a fire, electric shock, or other damage or
injury.
a
Turn off the projector and unplug the power cord.
b
Allow the projector lamp to cool down for at least one hour.
c
Use the screwdriver included with the replacement lamp to loosen the
screw securing the lamp cover.
Warning
When replacing the lamp, there is a possibility that the lamp may be
broken. If replacing the lamp of a projector which has been installed on the
wall or ceiling, you should always assume that the lamp is cracked, and you
should stand to the side of the lamp cover, not underneath it. Remove the
lamp cover gently. Be careful when removing the lamp cover as shards of
glass may fall out and could cause an injury. If any shards of glass get into
your eyes or mouth, contact a doctor immediately.
To Next Page
Loading...
Need help?
General
