Image Shape
60
a
To reset the Arc Correction settings, hold down [Esc] for about
two seconds while the area selection screen is displayed, and then
select Yes.
h
Press the arrow buttons to adjust the image shape of the selected area as
necessary.
To return to the area selection screen, press [Enter].
a
If you see this screen, you cannot adjust the shape any further in
the direction indicated by the gray triangle.
i
Repeat steps 7 and 8 as needed to adjust any remaining areas.
j
When you are finished, press [Esc].
a
To save the current shape of an image you have adjusted, select
Save Memory in the Arc Correction setting. You can save up to
three image shapes in the Arc Correction memory.
gg Related Links
• "Loading Image Shape Setting from Memory" p.60
Loading Image Shape Setting from Memory
You can load the settings you made and saved in the Arc Correction setting.
a
Before loading the memory, make sure the Geometry Correction
setting is set to Arc Correction in the projector's Settings menu.
a
Turn on the projector and display an image.
To Next Page
Loading...
Need help?
General
